KVH
Darth Vader
Offline
I had this done at a great shop but they look strange. I see three bearing holes in at least two of the bearings--the one for the locating bolt, one dry one I can't explain, and a smaller one to the oil galley. It looks like the shop may have needed to drill the one to the galley, but I can't tell. I'll call and ask them. It's a bit smaller than the other two.
Should they all line up, or is some machining typically needed? It's too awkward for pictures since a couple of the holes (maybe all) are on the upper part of the bearing.
Thanks.
Should they all line up, or is some machining typically needed? It's too awkward for pictures since a couple of the holes (maybe all) are on the upper part of the bearing.
Thanks.