fogliner
Senior Member
Offline
The picture shows the part that was found in the bottom of both the float bowls on my HS4's,buried in the long dried lacquer and sediment.
Any Idea's on what it is? Perhaps a part off the original float for setting the level? Just curious.
The next question I have is on setting the float levels on HS4's with the new style "All Plastic" floats.
Where is the proper place to measure from?
I've read about using fibre washers to shim the needle seat to achieve the 1/8" gap between the machined lip on the floatbowl lid and the float but the float sits at an extreme angle when upside down.
The lowest part on the float is opposite the needle when upside down and I would think a 1/8" drill bit layed beside the needle and across and under the tip of the float to the opposite edge would be the way but if anyone can help it would be appreciated.
Mark
Any Idea's on what it is? Perhaps a part off the original float for setting the level? Just curious.
The next question I have is on setting the float levels on HS4's with the new style "All Plastic" floats.
Where is the proper place to measure from?
I've read about using fibre washers to shim the needle seat to achieve the 1/8" gap between the machined lip on the floatbowl lid and the float but the float sits at an extreme angle when upside down.
The lowest part on the float is opposite the needle when upside down and I would think a 1/8" drill bit layed beside the needle and across and under the tip of the float to the opposite edge would be the way but if anyone can help it would be appreciated.
Mark