Offline
I am now installing the Smitty conversion to Toyota gearbox to the engine. In the photo below please see points where I assume one would use a thin coat of high temp grease. 1. the shaft that the throw-out bearing rides on and 2. The pivot ball that the arm rotates against.
Am I correct about this? Thanks.
https://gallery.mac.com/linwoodrose#100049/clutch-20grease-20points&bgcolor=black
Lin
1960 BT7 in restoration
1959 Bugeye
Am I correct about this? Thanks.
https://gallery.mac.com/linwoodrose#100049/clutch-20grease-20points&bgcolor=black
Lin
1960 BT7 in restoration
1959 Bugeye