Tabcon
Jedi Warrior
Offline
I installed my head yesterday to get a look at my valve to liner clearances. All the valves are oversized, and as suspected, the intake valves require more clearance to fully open.
I taped and covered everything except the area I was working on and cut out the 4 eyebrows. The valves now clear the cylinder walls, but look very close on cylinders 4 and 2.
I don't want to make the eyebrows too large, or not large enough, so I was wondering if anyone has any advice or photos they could share.
Thanks!
I taped and covered everything except the area I was working on and cut out the 4 eyebrows. The valves now clear the cylinder walls, but look very close on cylinders 4 and 2.
I don't want to make the eyebrows too large, or not large enough, so I was wondering if anyone has any advice or photos they could share.
Thanks!