BillyB62
Jedi Trainee
Offline
All,
Ok, I'm at my wits end and I'm sure I'm just missing something. The OD transmission was rebuilt this Fall from Quantumechanics and I've just finished the install as part of my long winter maintenance. Attached is the way I've currently wired the overdrive unit and although I can hear the relay click, the OD unit never engages. I've swapped my car over to negative ground and added an alternator (thus eliminating the Control Box). I've added another fuse box to accommodate fuse on other things like the radio & heater. I've replaced/purchased all wiring harnesses (the main harness and both the upper & lower OD harnesses) from British Wiring this winter. The red tabs on the picture show where I have power all the time.
I've tried bypassing the OD switch on the dash by connecting the Yellow/Green wire directly to the Yellow wire that goes to the Isolator switches on top of the unit. When I engage the switch (or bypass the switch), I do get continuity on the Yellow/Purple wire to the OD solenoid, but nothing on the Yellow wire going to the Isolator switches.
Any help both reviewing the diagram or suggesting anything that'll get it running again would be appreciated.
Thanks in advance,
Ok, I'm at my wits end and I'm sure I'm just missing something. The OD transmission was rebuilt this Fall from Quantumechanics and I've just finished the install as part of my long winter maintenance. Attached is the way I've currently wired the overdrive unit and although I can hear the relay click, the OD unit never engages. I've swapped my car over to negative ground and added an alternator (thus eliminating the Control Box). I've added another fuse box to accommodate fuse on other things like the radio & heater. I've replaced/purchased all wiring harnesses (the main harness and both the upper & lower OD harnesses) from British Wiring this winter. The red tabs on the picture show where I have power all the time.
I've tried bypassing the OD switch on the dash by connecting the Yellow/Green wire directly to the Yellow wire that goes to the Isolator switches on top of the unit. When I engage the switch (or bypass the switch), I do get continuity on the Yellow/Purple wire to the OD solenoid, but nothing on the Yellow wire going to the Isolator switches.
Any help both reviewing the diagram or suggesting anything that'll get it running again would be appreciated.
Thanks in advance,