Offline
Bit of an odd question: in order to prep my Bugeye for shipping I need to get my MGB off of my lift so that I can get the Bugeye up there to finish a few small things. I've been doing a front suspension rebuild on the MGB, and I'm almost (but not quite all the way) done. I have the new bearing races installed in the hubs, but haven't set the hub shims yet or greased anything up. Not a huge project, but I'm tight on time
Would I be OK to just dry fit the hubs close enough, so that I can roll the car off the lift (maybe 20 feet of travel) or am I really better off getting them set and greased properly?
I don't like to be rushed working on my cars, but I have some urgency to get the Sprite set up so it can be shipped. Figured it was worth asking the brain trust here before I damage anything.
Would I be OK to just dry fit the hubs close enough, so that I can roll the car off the lift (maybe 20 feet of travel) or am I really better off getting them set and greased properly?
I don't like to be rushed working on my cars, but I have some urgency to get the Sprite set up so it can be shipped. Figured it was worth asking the brain trust here before I damage anything.