Offline
So I was out in the shop today working on the trans crossmember for my MGB project and contemplating Doc's question as to if I had checked the bearing shells while I was replacing the oil pan gasket. (I hadn't.) So I contemplated false economy and flipped the engine back over so I could get to the bottom end.
My goal is not to rebuild this engine, but if there are things I can do that are close at hand I'll do them. Good chance to learn a bit as well and maybe extend the life of this engine a few more years.
So I've not got any experience with engine innards, so I need some guidance. What to check, what to replace?
My goal is not to rebuild this engine, but if there are things I can do that are close at hand I'll do them. Good chance to learn a bit as well and maybe extend the life of this engine a few more years.
So I've not got any experience with engine innards, so I need some guidance. What to check, what to replace?