• Hi Guest!
    If you enjoy and benefit from your participation at British Car Forum, please consider supporting our efforts with a subscription.

    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this banner)
Tips
Tips

worn Webber carb

BobS76

Senior Member
Offline
I had taken my car to my local mechanic for a tune up (yes, there are some things that I will pay someone else to do). He said that the nosie I had been hearing was coming from my carb - the shaft holding the choke plates had badly worn out the carb body and was rattling. Short of buying a new carb, is there anything that I can do? I have a Webber DGV down draft.
 
Fred Mcconnell (blackmgb) has one listed for sale over at the MGBE trader section. That may be a reasonable fix to your problem. bob
 
If you are talented with this sort of thing, or have a tame machinist, make a couple of bushings, and fix the existing air horn. If you had some tubing that the choke shaft fit well in, and turned down a section on 2 pieces, drill the air horn for a loose but press fit, and viola, you are good to go. Leave the larger diameter of the new bushings on the outside of the air horn to prevent inadvertant swallowing of small parts, and a little locktite... Good to go.
 
Well guys, thanks for the response.

Ron - I tried the overseas-auto link but did not see any reference to classic motorsports.

bob67bgt - What is the MGBE trader section?

Jesse - I may want to save this as a last resort.

Anyone - I did find a DGEV for sale, new, for $269 : www.WEBBERCARBSDIRECT.COM. Carb only, not manifold, etc. Does this sound like a good price? Is anyone familiar with this company?
Thanks,
Bob
 
The ad is in the issue of Classic Motorsports. It describes the shaft bushing kit in the ad..
 
Similar threads
Thread starter Title Forum Replies Date
V GT6 Shifter Worn? Triumph 2
K TR2/3/3A Using a dial gauge to adjust valves when rocker arm surfaces are worn? Triumph 9
F Three worn hubs and wire wheel centers - What to do next? 1960 BT7 Austin Healey 6
2 Wanted SU-h6 Carb. BODY ONLY needed, badly worn. for TR3A Triumph Classifieds 5
aeronca65t Worn clutch bits, etc Spridgets 11
H TR4/4A Worn Fulcrum pins Triumph 5
L 100 timing chain worn? Austin Healey 7
5 Worn steering box Austin Healey 4
Rob Glasgow Worn Hub Extension Studs Austin Healey 2
TulsaFred What are the symptoms of worn throttle shafts? Spridgets 9
M Worn out throw out bearing Spridgets 4
mgnewbie worn/old front suspension bushes MG 3
PatGalvin TR2/3/3A TR3 Upper Wishbone Fulcrum Pins? Too Worn? Triumph 6
davester Is this normal for a worn out clutch? Spridgets 2
M Front hub worn out Spridgets 6
livinginthepast Anyone have a worn out old 948 engine for sale? Spridgets 9
TR6oldtimer TR6 Worn Thrust Bearings TR6 Triumph 26
M Tire Worn Uneven Spridgets 4
Tinkerman Worn Shifter Forks Triumph 6
jcatnite Worn gears Spridgets 15
Thor Do you have to ream swivel axle if not worn? Spridgets 6
Mark Jones Differential nut removal & worn thurst washer Triumph 1
Bob_Carroll TR6 Worn #1 Exh Cam Lobe - TR6 Triumph 9
G Webber DGV Jetting FORUM Navigation Questions 5
G Trade Webber DGV Jetting Triumph Classifieds 0
DNK Webber carbs for 4 Cy. Triumph 7
B Webber DGAV3D Spridgets 22
humanoid replacement air filters for dual Webber carbs Triumph 19
J Webber MCHH Carbs? Triumph 4
SilentUnicorn Gas Mileage SU vs Webber MG 12
P ideal fuel pressure for webber or dellorto carbs Triumph 11
K TR2/3/3A The carb linkage "bell crank". Triumph 9
Govtslug TR6 Carb Problem Triumph 8
W 2024 HD8 Carb Rebuild Austin Healey 4
K TR2/3/3A A TR3 plug check left to right 1234...do I lean out front carb a couple of flats?...turn down correct? Triumph 3
J Spitfire Carb Conundrum Triumph 3
J Spitfire SU Carb Jet Assembly Seized Triumph 1
C LCB header with 1500 single carb inlet manifold Spridgets 1
Southwarks TR2/3/3A Carb balance woes Triumph 6
K TR2/3/3A Adjusting the H6 SU carb jet? Triumph 1
S Weber carb set Other British Cars 7
S Spitfire Triumph Spitfire 1300 engine SU carb problem Triumph 10
S Carb Problem Austin Healey 13
S Leaking HD6 Rear Carb Austin Healey 10
wangdango Carb Rebuild Necessity Austin Healey 3
M New Member with an HD8 Carb Question Austin Healey 1
craigshealey3000 Carb Tuning for Cold Starts Austin Healey 2
J TR6 Stromberg Carb Mixture Adjustment Triumph 6
G HD8 Carb Leak Austin Healey 7
K TR2/3/3A RE: Pulling the choke knob all the way out....the carb jets should be down how far? Triumph 5

Similar threads

Back
Top