• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

TR6 Boot lid thread plates loose in stiffener

Share this page

B

blokey

Freshman Member
Country flag
Offline
I am refinishing the boot lid on my TR6 and noticed that the threaded plate for attaching the boot lid to the hinge is loose and rattling around inside the reinforcing stiffener. The factory must have used some sort of adhesive to keep the plate in position while allowing some movement for aligning the hinge to the boot lid. Can someone suggest a method for keeping the plates in place?

thanks in advance
 
When you tighten down the hinges they will stop moving. Just get them sung enough to move so you can line up the seams around the lid.
Don't get upset if it takes a few tries to get it right and some towels around the edges wouldn't hurt.
 
Back
Top